Hobbywing XRotor Micro 40A 4in1 ESC and FC F7 Combo/Stack

Hobbywing XRotor Micro 40A 4in1 ESC and FC F7 Combo/Stack

0 reviews Write a review
  • US $125.00

    US $8999

  • Product Code: HW-combo-XR-40A
  • Availability: In Stock


XRotor Micro 40A 4in1 ESC&FC F7 Combo

  • ESC: XRotor Micro 40A 4in1 BLHeli-32 DShot1200
  • FC: XRotor XRotor Flight Controller F7
  • Applications: 130-300mm FPVs


XRotor Flight Controller F7

  • Super hardware and running speed: Equipped with STM32F722 MCU which has powerful computing ability and fast running speed, and high sensitivity ICM20602 six-axis motion sensor. It can perfectly support bidirectional DShot digital throttle communication. The integrated OSD chip can adjust and set each OSD parameters in FC parameter adjustment software and radio, which is simple and convenient. On-board large capacity Flash memory chip can record and store more flight logs, which is convenient for users to debug aircraft based on flight data.
  • Special interface for DJI image transmission system: With DJI image transmission system port, equipped with corresponding flat cable (FC has been equipped), can avoid welding, realize plug and play.
  • On-board 5V & 12V dual BEC circuit: FMU integrates with 12V BEC circuit. It can supply super power output for image transmission and 12V LED devices.
  • On-board Pit Switch module: FC integrated Pit Switch module can open or close VTx by radio after being adjusted on FC parameter software. Easy and convenient.
  • Perfectly support firmware of various FPV: It support the firmware of BetaFlight , Cleanflight , Butterflight , inva and other mainstream FPV, and can use corresponding parameter adjustment software to adjust various parameters, making the FC more suitable for various FPV flight and race.
  • Unique installation design and shock absorption structure: The double hole distance mounting hole design (30 * 30MM & 20 * 20MM) can adapt to different frames. The unique flexible flat cable connection mode (The effect is better with hobbywing tower 4in1 ESC ), and the shock absorption mechanism of installation hole, can effectively reduce the impact of external vibration on FC high-sensitivity components, and make the flight more stable and accurate.
  • Perfectly match with Hobbywing ESC: Match with Hobbywing tower 4in1 ESC, easy to install and wire. The appearance is more beautiful.

XRotor Micro 40A 4in1 BLHeli-32 DShot1200

  • High performance 32-bit microprocessor with the running frequency of up to 48MHz for excellent performance.
  • BLHeli_32 firmware is the third generation BLHeli, following base BLHeli and BLHeli-S.
  • All codes use damped light mode. Damped light does regenerative braking, causing very fast motor retardation, and inherently also does active freewheeling.
  • The code supports features to prevent sync loss. There are tunable parameters that can make the code run well even in the most demanding situations, although default settings will work excellently in normal operating environment
  • The code supports regular 1-2ms pulse width input, as well as Oneshot125 (125-250us), Oneshot42 (41.7-83.3us) and Multishot (5-25us).
  • Dshot signaling is supported at any rate up to at least Dshot1200. The input signal is automatically detected by the ESC upon power up.
  • The code also supports a beacon functionality, where the ESC will start beeping after a given time of zero throttle. This can be very useful for finding lost crafts.


XRotor Flight Controller F7

  • FC Programming: Supported
  • Programming via: Betaflight/Cleanflight-configurator
  • Compatible with (Modes): PWM, Oneshot125, Oneshot42, Multishot, Dshot150, Dshot300, Dshot600, DShot1200, Proshot1000
  • Compatible with (Transmitters): PPM, Spektrum, SBUS, SUMD, SUMH, XBUS, IBUS, JETIEXBUS, CRSF, SRXL
  • OSD: Built-in
  • Voltage Monitoring: Supported
  • Current Monitoring: Supported
  • External Buzzer: Supported
  • LED Control: Supported
  • BEC: 5V @ 1.5A ; 12V @ 1.5A
  • USB Port: MicroUSB
  • Size: 32x32mm
  • Weight: 3.3g

XRotor Micro 40A 4in1 BLHeli-32 DShot1200

  • LiPo Power input: 3S-6S
  • Cont.Current: 40Ax4
  • Burst Current: 60Ax4
  • BEC Output: NO
  • Input wires: 14AWG-100mm* (Red/Black)
  • Output Wire: No wires but solder tabs
  • Connectors: (In/Out) - XT60 plug enclosed with package.
  • Weight / Size: 12g / 40x33x5mm
  • Firmware: Hobbywing_XRotor_BLHeli-32 Version
  • Throttle Calibration: Supported
  • ESC Programming: Stick Programming, BLHeliSuite32
  • DEO: Supported
  • OneShot Mode: Supported
  • Timing: Supported
  • Motor Rotation: Supported 

Reviews (0)

Write a review

Please login or register to review